[a121]

Try mo sa Thermalec sa Fairview. Dun nagpagawa friend ko ng rollcage sa race car nya.

[michaelrtp]

I'm using fabricated Front Strut Bar and Sway Bar (both UR spec) from ETM trading, sinabayan ko na din ng KYB Rear Coilspring and wider tire (15x7)

Before this upgrade, sinusubukan ko ang spirited driving pero nakakatakot dahil sa excess body roll, na parang any mishandling eh tataob na yung kotse, using stock GLX wheelset as well which is sobrang nipis pa.

After the upgrades, believe me sobrang ganda na ng handling, reduced body roll and hindi na din nag bbottom out

[AJ12Gamer]

Ok thanks guys. The reason why i bought a mirage cause it was cheap. Kung kaya ko lng bumili ng Subaru, Subaru nlng sana binili ko hehe.

Tanungin ko sila speedlab kung kaya nila gumawa nng sun roof tapos update ko kayo d2 para kung kasali may gusto rin magpagawa sa inyo ng sun roof, Alam niyo n price.

Sino po na frabricate na strut d2? Pengi number nila. And kung mas mura. Bibili aq.

Cge try ko din Thermalec sa Fairview.

How much na gastos mo micheal sa ETM trading?

[michaelrtp]

@AJ12Gamer pm sent po.

[AJ12Gamer]

Thanks for the private message michealrtp but why private? Kung 7.5k both bars? Try ko muna sa machine shop. Sabi dw bending, cutting, at welding. Labor nila 1k. Ask ko galvasteel makano A500 Grade A carbon steel bar. Sana 1k din. Update ko kayo.

[arjee]

(07-26-2017 05:32 AM)AJ12Gamer Wrote:  Thanks for the private message michealrtp but why private? Kung 7.5k both bars? Try ko muna sa machine shop. Sabi dw bending, cutting, at welding. Labor nila 1k. Ask ko galvasteel makano A500 Grade A carbon steel bar. Sana 1k din. Update ko kayo.

I will take this with a grain of salt. Most 958Mpa rated high tensile strength steel are not compatible with weldings. Not even TIG weldings. the 958mpa - 990mpa rated steels are the same used in the chassis of the new mazda3 and Honda civic. You can read the infos and reasons why in their technical bulletins. For the meat of it - weldings will make the chassis brittle and will crack under pressure. this is the reason why high strength adhesives are used in the bonding of some structural panels for rigidity.

The following 1 user Likes arjee's post: jantre2001

[michaelrtp]

(07-26-2017 05:32 AM)AJ12Gamer Wrote:  Thanks for the private message michealrtp but why private? Kung 7.5k both bars? Try ko muna sa machine shop. Sabi dw bending, cutting, at welding. Labor nila 1k. Ask ko galvasteel makano A500 Grade A carbon steel bar. Sana 1k din. Update ko kayo.

I don't want to divulge any information publicly. I'm not even affiliated with ETM trading at all. I hope you get this.