Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DIY Armrest / Center Console
09-24-2013, 10:52 PM
Post: #1
DIY Armrest / Center Console
DIY CENTER CONSOLE / ARMREST

1. Remove the center console:
A. Remove the two front clips.
B. remove the center console cover below the handbreak lever.
C. Remove the bolt on the rightside under the center console cover.
D. Remove the rear bolt by opening the rear console cover.
[Image: 6ybarepe.jpg]

I didn't bother to fully remove the center console cause the cable of aux/usb port won't detach from the console.

2. Install the floor bracket at the bottom part parking brake and install the two bolts that came with thecenter console package.
[Image: 5e5u4eve.jpg]
[Image: eqa3a3u9.jpg]

3. Cut the paper illustration included in the instruction papers. This will be your guide on where to locate the three marks to drill for the bolts.
[Image: gysaje7u.jpg]

4. Place the cut paper on the center console and putthe upper part of the bracket to mark the three areas to be drilled by drill bit with 3mm-8mm size.
[Image: u6ypa4e9.jpg]

5. Install the upper bracket with the three bolts provided in the package.
[Image: 2arudu2e.jpg]

6. Install the armrest console using the 4 screws provided.
[Image: eqy4u3ar.jpg]

7. Re-install the center console:
A. Re-install the bolt on the rightside under the center console cover.
B. Re-install the center console cover below the handbreak lever.
C. Re-install the rear bolt and closed the rear console cover.
D. Re-install the two front clips.
[Image: eqeny9aj.jpg]
[Image: pe9uruty.jpg]

I didn't cut or trim anything on the center console as instructed on the manual cause it looks good without the trimming and it fits well.


 
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 01:29 PM
Post: #2
RE: DIY Armrest / Center Console
Sir question..

Is this the same oem armrest na binebenta ni mr. rallyparts? I thought kasi kapag pinalitan ng armrest yung cup holder sa gitna ng dalawang front seats mapapalitan ng armrest at hindi papatungan lang? Medyo naguguluhan hehe. Thanks.

[img][Image: 6ig1af.jpg][/img]
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 02:08 PM
Post: #3
RE: DIY Armrest / Center Console
^^ hello po kung yung OEM na centerconsole...mapapatungan po talaga yung cupholder sa gitna, doon yung bubutasan, then ipapatong doon yung centerconsole based on instructions.

Meron ako nito pero di ko pa nakakabit...
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 02:19 PM
Post: #4
RE: DIY Armrest / Center Console
^^ Hello po. This would be my first upgrade if ever. Do you think maam jaycee kaya sya i-DIY with all the instructions & everything?

[img][Image: 6ig1af.jpg][/img]
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 02:33 PM
Post: #5
RE: DIY Armrest / Center Console
^^ ako kasi natatakot ako hahaha...kaya ko magbaklas...yung pagbubutas prob ko...pinag-iisipan ko pa ng maige.... 4
malalaman mo after ng 5K ko...make or break kasi yun pag di ko pa nagawa by that time...ipapagawa ko na lang sya sa casa...4.8K+++ na ako ngayon
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 02:48 PM
Post: #6
RE: DIY Armrest / Center Console
200 kms more to go hehehe. Would you know kung magkano sisingilin na labor ng casa maam? Based kasi dito mukhang 50-50 din ako dahil one shot deal to kapag nagkamali ng butas. Pero kung malinaw naman ang instruction sa manual baka kaya naman DIY.

[img][Image: 6ig1af.jpg][/img]
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 02:56 PM
Post: #7
RE: DIY Armrest / Center Console
^^ haha sandali lang ang 200KMS sa akin...roadtrip girl on board po....

di ko alam magkano sisingilin nila...papakiusapan ko na lang yung installer pag may time hehehe
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 03:04 PM
Post: #8
RE: DIY Armrest / Center Console
Knowing casa baka hindi bababa sa 500 ang labor charge nyan maam pero baka makuha naman sa charm at babaan nila ng konti or libre na lang hihihi.

[img][Image: 6ig1af.jpg][/img]
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 05:11 PM
Post: #9
RE: DIY Armrest / Center Console
Mitsubishi Valle Verde was gonna charge me P1,200 for the labor of installing the armrest console when I purchased my Mirage.

Buti na lang kinausap ng SA ko yung installer. Pumayag siya na P600 na lang, pero walang receipt yung bayad ko, under the table kumbaga.
Find all posts by this user
Like Post Quote this message in a reply
09-25-2013, 07:04 PM (This post was last modified: 09-25-2013 07:10 PM by Donnvill.)
Post: #10
DIY Armrest / Center Console
(09-25-2013 01:29 PM)NaimaRaiko Wrote:  Sir question..

Is this the same oem armrest na binebenta ni mr. rallyparts? I thought kasi kapag pinalitan ng armrest yung cup holder sa gitna ng dalawang front seats mapapalitan ng armrest at hindi papatungan lang? Medyo naguguluhan hehe. Thanks.

I think sirits the same thing kasi oem din po yung kay sir rallyparts..


 

(09-25-2013 02:19 PM)NaimaRaiko Wrote:  ^^ Hello po. This would be my first upgrade if ever. Do you think maam jaycee kaya sya i-DIY with all the instructions & everything?

Sir dali lang po nito i diy.. Siguro it will take 45 mins to 1 hour po.. Pero di naman po mahirap..

Sa citimotors makati kasi they are asking for 1,600 for the installation po. Kaya sabi ko wag na lang other mods na yun..


 

(09-25-2013 02:33 PM)jaycee Wrote:  ^^ ako kasi natatakot ako hahaha...kaya ko magbaklas...yung pagbubutas prob ko...pinag-iisipan ko pa ng maige.... 4
malalaman mo after ng 5K ko...make or break kasi yun pag di ko pa nagawa by that time...ipapagawa ko na lang sya sa casa...4.8K+++ na ako ngayon

Yun din problema ko nung una pano ko bubutasan pero pag may drill bit kasi madali lang po tlga. Markahan mo lang ng pencil.


 

(09-25-2013 05:11 PM)TomE Wrote:  Mitsubishi Valle Verde was gonna charge me P1,200 for the labor of installing the armrest console when I purchased my Mirage.

Buti na lang kinausap ng SA ko yung installer. Pumayag siya na P600 na lang, pero walang receipt yung bayad ko, under the table kumbaga.

Mas mura pa nga sa mitsu valle verde compare to makati sakin ang charge 1,600 daw sabi ko wag na lang..


 
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)

This forum uses Lukasz Tkacz MyBB addons.