Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DIY: DLAA Foglights Installation (without drilling & splicing)
04-12-2017, 07:34 AM
Post: #21
RE: DIY: DLAA Foglights Installation (without drilling & splicing)
mr joed... question lang..what if nakasplit yung yellow wire into two.one going with low relay one with high relay? para pag naghigh ka may foglights pa din..

pagnakahigh beam the lo relay turns off and mag on naman yung hi relay what do you think? and vice versa..

mukha bang possible ito?

"JUST CHARGE IT TO EXPERIENCE"
BGC CREW - TOOTHLESS
[Image: rNR0ieQ.jpg]
Find all posts by this user
Like Post Quote this message in a reply
05-19-2017, 07:16 PM
Post: #22
DIY: DLAA Foglights Installation (without drilling & splicing)
(04-12-2017 07:34 AM)EngrRobee Wrote:  mr joed... question lang..what if nakasplit yung yellow wire into two.one going with low relay one with high relay? para pag naghigh ka may foglights pa din..

pagnakahigh beam the lo relay turns off and mag on naman yung hi relay what do you think? and vice versa..

mukha bang possible ito?


Sorry for the late reply, been busy at work these past months. Anyway, i think di po siya pwede. Posible na pag tinurn-ON ang headlight low, and if connected siya sa headlight (high) relay, magssupply din siya ng power sa headlight high at sabay iilaw ang low at high headlight. Di yun kakayanin ng oem relay at wirings at posible na magcause ng short circuit.


 
The following 1 user Likes joedfelipe's post:
jantre2001
Find all posts by this user
Like Post Quote this message in a reply
05-28-2017, 07:05 AM
Post: #23
RE: DIY: DLAA Foglights Installation (without drilling & splicing)
@joed , mine instead of park light nka tap yun switch (para sa needed power ng switch) , sa accessories wire ko sya tap using ez tap connector, khit mkalimutan nka on fog lamp, pg patay engine patay na rin

 
Find all posts by this user
Like Post Quote this message in a reply
03-06-2018, 03:12 PM
Post: #24
RE: DIY: DLAA Foglights Installation (without drilling & splicing)
Hello sir joedfelipe. Planning to install on my G4. Kamusta po ba performance and durability ng DLAA foglamps? Di po ba nangingitim ang lens? Di rin ba too hot kahit sandali lang naka ON?

May nabasa kasi akong reviews the DLAA foglamps get too hot.
Find all posts by this user
Like Post Quote this message in a reply
03-06-2018, 09:10 PM
Post: #25
RE: DIY: DLAA Foglights Installation (without drilling & splicing)
Nicely done sir, i had mine and gawa ng ka crew ko from EASTCREW. You can search him at FB Jaz Azi is the name 1

zhe
- jarvis red -
Find all posts by this user
Like Post Quote this message in a reply
03-15-2018, 09:38 PM
Post: #26
RE: DIY: DLAA Foglights Installation (without drilling & splicing)
I used this post as a guide to install DLAA fog lights for my G4. It works! thanks sir!
Find all posts by this user
Like Post Quote this message in a reply
Post Reply 




User(s) browsing this thread: 1 Guest(s)

This forum uses Lukasz Tkacz MyBB addons.